Differences

This shows you the differences between two versions of the page.

--- en:reactivity:radical_addition:empiric [2026/09/23 10:07] – abc
+++ en:reactivity:radical_addition:empiric [2026/09/23 10:26] (current) – abc
@@ Line 10: / Line 10: @@
 where //L<sub>i</sub>// and //x<sub>i</sub>// are parameters of a radical, and //M<sub>j</sub>// and //x<sub>j</sub>// – of a monomer (//x// is electronegativity of a reactant; //L// и //M// collect entropy, nonpolar effects, and so on). Since only relative rate constants of radical addition to monomers were considered (//ln k<sub>ij</sub>/k<sub>ik</sub>//), parameter //L// never appeared. Parameterization of the scheme was accomplished on the basis of approximately 200 rate constants [  [[ref|1, 7, 9]] ] of reactions between 20 chosen radicals and 20 vinyl monomers. All obtained parameters are shown in Table IX (see more data in Ref. [ [[ref|10]] ]). Comparison of calculated values with experimental data are shown in Figure 7. It enables us to say that the proposed scheme describes these experimental data reasonably well (the mean deviation is less than 50%, the precision of those kinetic data themselves). So, the form of **Eq. (4)** is both meaningful and adequate for the purposes of nonlinear correlation tasks. It is relevant to add here that all parameters also "correlate" with common chemical views on donor–acceptor properties of both the radicals and monomers that were considered.
+**TableIX**. Optimized parameters of reagents, **Eq. (4). Const = 27.5**
+^  Monomers  ^^  |  ^  Radicals  ^^
+^  ^  M  ^  x    | ::: ^  ^  x  ^
+| //St//  |  **0**((Styrene parameters were used as reper values.)) |  **0**  | ::: | //CH<sub>3</sub><sup>•</sup>//  |  0.477  |
+| //MSt//((Additional abbreviations of vinyl monomers: //MSt//, α-methylstyrene; //MAN//, methacrylic nitryl; //MMA//, methyl methacrylate; //IPA//, isopropenylacetate; //VBuE//, vinyl buthyl ether; //ViPy//, vinylpyridine; //MVK//, methylvinylketone; //DPE//, diphenylethene; //VF//, vinyl fluoride)) |  0.284  |  0.0081  | ::: | //t-Bu<sup>•</sup>//  |  0.518  |
+| //AN//  |  −1.908  |  −0.0559  | ::: | //c-C<sub>6</sub>H<sub>11</sub><sup>•</sup>//  |  0.587  |
+| //MAN//  |  −1.585  |  −0.0218 | ::: | //5-C<sub>6</sub>H<sub>9</sub><sup>•</sup>//  |  0.528  |
+| //MA//  |  −2.085  |  −0.0482  | ::: | //C<sub>6</sub>H<sub>5</sub><sup>•</sup>//  |  0.310  |
+| //MMA//  |  −1.006  |  −0.0315 | ::: | //C<sub>6</sub>H<sub>5</sub>-S<sup>•</sup>//  |  −0.534  |
+| //VA//  |  −4.582  |  −0.0285  | ::: | //t-BuO<sup>•</sup>//  |  −0.482  |
+| //IPA//  |  −4.061  |  −0.0149 | ::: | //t-BuOO<sup>•</sup>//  |  −0.541  |
+| //VBuE//  |  −5.200  |  0.0102 | ::: | //PhC(CH<sub>3</sub>)<sub>2</sub>OO<sup>•</sup>//  |  −0.372  |
+| //2-ViPy//  |  0.251  |  −0.0122  | ::: | //CCl<sub>3</sub><sup>•</sup>//  |  −0.204  |
+| //4-ViPy//  |  −0.023  |  −0.0114 | ::: | //CF<sub>3</sub><sup>•</sup>//  |  −0.627  |
+| //1,1-DPE//  |  1.216  |  0.0122  | ::: |    |
+| //1,2-DPE//  |  −1.660  |  0.0093 | ::: | //poly-St//((polyalkyl radicals //∼CH2−C<sup>•</sup>HY//, generated from vinyl monomers in polymerization))  |  0.446  |
+| //VCl//  |  −3.034  |  −0.0253  | ::: | //poly-MSt//  |  0.598  |
+| //VCl2//  |  −2.097  |  −0.0449 | ::: | //poly-AN//  |  −0.293  |
+| //VF//  |  −5.087  |  −0.0219   | ::: | //poly-MAN//  |  0.072  |
+| //VF2//  |  −3.522  |  −0.0604  | ::: | //poly-MA//  |  0.157  |
+| //Eth//  |  −4.431  |  −0.0167  | ::: | //poly-MMA//  |  0.088  |
+| //MVK//  |  −1.729  |  −0.0561  | ::: | //poly-VA//  |  0.067  |
 ----
+There are experimental data on reactivity of radicals and vinyl monomers that have substituted benzoic ring in theirs structure. In the process of parametrization we assumed that substituent in such aromatic compounds only shifts EN of the reagent: //x<sub>i</sub>=x<sub>H</sub> + ρ·σ<sub>i</sub>//, where //ρ// is the sensitivity quotient and //σ<sub>i</sub>// is the parameter of substituent (they correspond both by the meaning and value the Hammett's //ρ/σ// parameters [ [[ref|2]] ]); see Table X.
+**Table X**. Parameters((gained by optimization procedure)) of substituents (//σ//) in aromatic ring. Sensibility of aromatic groups for substitution (//ρ//).
+^ substituent  ^  //σ//((//σ<sub>H</sub>// = 0))  |  ^ Group  ^  //ρ//  ^
+| p-NH<sub>2</sub>  |  0.111  | ::: | Ph-S<sup>•</sup>  |  1.0((//ρ<sub>PhS</sub> = 1// was set as the reper value))  |
+| p-OCH<sub>3</sub> |  0.042  | ::: | PhCH=CH<sub>2</sub>  |  0.145 |
+| p-CH<sub>3</sub>  |  0.004  | ::: | PhCH<sup>•</sup>∼  |	 0.936  |
+| p-Cl  |  −0.013  | ::: | Ph<sup>•</sup>  | 2.4  |
+| p-Br  |  −0.009  |
+| p-CN  |  −0.030  |
+| p-NO<sub>2</sub>  |  −0.041  |
+{{:reactivity:radical_addition:empiric-3.png?direct&300 |}}
+**Figure 7**. Relationship between experimental relative rate constants and calculated values by **Eq. (4)**.
+**[[calculator|TRY ONLINE CALCULATOR]]**
+----
+[ [[.:empiric2|Next]] ] [ [[.:|Top]] ]